H3 Base
Screw-base lamp for fog lights and rear fog lights – PK22s.
Vorteile
- Secure screw mounting
- Robust under vibration
- Cheap
Nachteile
- Only fog/rear light
- Less LED choice
- Older base
approx. 5–15 € (pair) UVP inkl. MwSt. · Preis kann je nach Händler variieren
H3 Base im Detail
The H3 uses a screw base (PK22s) and is designed specifically for fog lights and rear fog lights. The yellowish light color (halogen) improves visibility in fog.
Technical usage
Application area: Fog light / rear fog light. Power: 55 W bei 12 V, Luminous flux approx. 1450 lm. Color temperature: 3200 K (Halogen).
Dimensions
Base diameter 22 mm (threaded PK22s), total length approx. 42 mm
History
The H3 base (PK22s) is a screw-base lamp used since the 1970s for fog lights and rear fog lights. Its screw base allows especially secure mounting in vibration-prone areas.
Vehicle classes / sizes
- All classes
- Commercial vehicles
- Trailers
Specifications
| Base | PK22s |
| Rated power | 55 W |
| Rated voltage | 12 V |
| Luminous flux | approx. 1450 lm |
| Color temp (halogen) | approx. 3200 K |
| Lifespan | 400–800 h |
| Use | Fog light, rear fog light |
| Mounting | Screw base |
Suitable H3 bulbs on Amazon
Popular and proven lamps with this base – research and direct links to Amazon.
Tips for replacement and LED retrofit
- Safety: Ignition off, key removed, let the lamp cool (halogen gets very hot).
- Do not touch the glass: Fingerprints shorten lifespan – use gloves or a cloth.
- LED retrofit: Only with E-mark (ECE R37/R112) allowed, otherwise the operating license is void and glare may result.
- CAN bus errors: With LED the vehicle may report a fault – use LED with CAN-bus resistor or special "canbus" lamps.
- Replace both sides: When one lamp fails, replace the opposite side too to avoid color/brightness differences.
- Extend lifespan: Check voltage stabilization, clean contacts, waterproof caps.
Frequently asked questions about the H3 Base
Longer wavelengths scatter less on water droplets.
Yes, with approved LED retrofit lamps.