H4 Base
Dual-filament lamp for low and high beam in one bulb – P43t base.
Vorteile
- Two light functions in one lamp
- Fewer openings in headlamp
- Cheap and proven
Nachteile
- Lower light output than separate H7
- Filaments can fail faster under vibration
- Low and high beam not independently optimizable
approx. 6–20 € (pair) UVP inkl. MwSt. · Preis kann je nach Händler variieren
H4 Base im Detail
The H4 combines low beam (55 W) and high beam (60 W) in one lamp with two filaments. The P43t base has three pins (ground + two filaments). Common in motorcycles and older vehicles since only one opening in the headlamp is needed.
Technical usage
Application area: Low and high beam. Power: 60/55 W bei 12 V, Luminous flux approx. 1650/1000 lm. Color temperature: 3200 K (Halogen).
Dimensions
Base diameter 43 mm (three-pin), total length approx. 73 mm
History
The H4 base (P43t) is one of the oldest vehicle lamp bases still in use. Introduced in the 1970s, it combines low and high beam in one lamp with two filaments. Long the standard, today mainly used in older vehicles and motorcycles.
Vehicle classes / sizes
- Compact cars (older)
- Motorcycles
- Commercial vehicles
- Classics
Specifications
| Base | P43t |
| Rated power | 60/55 W (high/low) |
| Rated voltage | 12 V |
| Luminous flux | approx. 1650/1000 lm |
| Color temp (halogen) | approx. 3200 K |
| Lifespan | 300–600 h |
| Use | Low and high beam |
| Pins | 3 |
Suitable H4 bulbs on Amazon
Popular and proven lamps with this base – research and direct links to Amazon.
Tips for replacement and LED retrofit
- Safety: Ignition off, key removed, let the lamp cool (halogen gets very hot).
- Do not touch the glass: Fingerprints shorten lifespan – use gloves or a cloth.
- LED retrofit: Only with E-mark (ECE R37/R112) allowed, otherwise the operating license is void and glare may result.
- CAN bus errors: With LED the vehicle may report a fault – use LED with CAN-bus resistor or special "canbus" lamps.
- Replace both sides: When one lamp fails, replace the opposite side too to avoid color/brightness differences.
- Extend lifespan: Check voltage stabilization, clean contacts, waterproof caps.
Frequently asked questions about the H4 Base
60 W for high beam, 55 W for low beam – two separate filaments.
No, base and reflector geometry differ.