✓ Independent tests ✓ Customer reviews checked ✓ As of November 2026 ✓ No advertising influence
Care guide

Caring for and storing your snow blower

A well-maintained snow blower lasts many winters. After use, a quick check is enough; in summer the machine needs dry storage. With our tips, the machine stays ready for use.

After every use: the five-minute routine

  1. Switch off the motor and remove the battery. This is the most important safety rule before you clean the discharge chute.
  2. Empty the discharge chute. Remove snow and ice residue with the cleaning scraper or a wooden stick. Never reach in with your hand.
  3. Check the auger and housing. Remove stones, branches and dirt. On metal augers, look for cracks and bends.
  4. Check screws and fasteners. Vibration can loosen screws.
  5. Let it dry. Moisture and ice in the housing can damage bearings and contacts.
Salt and grit After use on gritted surfaces, rinse off salt residue with clear water. First remove the battery and do not spray the electrics with high pressure. Then let the machine dry thoroughly.

Caring for batteries

Batteries are the most expensive wear part of a cordless snow blower. A few simple rules will keep them fit for a long time:

  • Store frost-free: Cold reduces performance. After use in frost, let the battery reach room temperature before you charge it.
  • Store partly charged: For summer storage, set the charge to about 40 to 60 percent and keep the battery cool and dry.
  • Keep contacts clean: Snow and moisture can attack the contacts in the machine and the battery. Keep them dry.
  • Keep out of sunlight: High temperatures in a car or garage shorten the service life.

Petrol snow blowers: summer check

Petrol models need more detailed maintenance. The fuel ages, seals become brittle and the carburettor can gum up. Before storage:

  • Drain the fuel or use a fuel stabiliser, and run the engine briefly so that the carburettor empties.
  • Change the engine oil. Many manufacturers specify their own 4-stroke oils for snow blowers, for example 5W-30.
  • Check the spark plug and replace it if necessary.
  • Lubricate the auger gears, drive cables and steering linkage.
  • Store the machine dry and covered in a well-ventilated room. Never test it in a closed room with the engine running.

Summer storage

  • Clean the machine thoroughly, including the discharge chute and the wheels.
  • Store it dry, ideally with a dust cover.
  • Check screws and fasteners, and order wear parts if necessary.
  • Store the batteries separately, see above.
  • Fold the handle tube to save space. On some models such as the Einhell GE-ST 36/40, the handle tube can be split.

Common problems and solutions

  • Discharge chute blocked: Remove the battery, clear the snow with a scraper or stick. With wet snow, clear it again before it freezes.
  • Battery no longer charges: Check the contacts, test the charger, and let the battery thaw out first if it was cold.
  • Machine is hard to push: Check the wheels and sliding surfaces. The scraper may be worn, or the housing may have ice in it.
  • Runtime drops noticeably: The battery has probably aged. Fully charge it before you replace the battery.